ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-34Figure 3–117. Tactical Relay Resistor Assembly Schematic Diagram(b)Touch other lead to terminals 3,2, and 1.(c)(15)(16)d. Assembly.Ohmmeter should indicate 7.5 ohms in each case.Replace defective components of tactical relay resistor assembly using figure 3-118 as a guide.If the wiring harness has sustained damage and requires repair or rebuild, refer to figure 3-112 forlayout, identification, and material requirements and Appendix A for detailed soldering andreplacement procedures.(1) Position relay assembly to install Iockwashers (2, figure 3-111) and screws (1).(2) Connect electrical leads to tactical relay assembly.e. Installation.(1) Position chassis (26, figure 3-111), to install wiring harness (25), screw& captive washer assembly(24), nut (23), screw & captive washer assembly (22), nut (21), ground screw (20), flatwashers (19),nut & captive washer assembly (18).(2) Install overload protective device (17), and screw& captive washer assembly (16).(3) Install short circuit relaly (15), over–voltage relay (14), reverse power relay (13), and screw& captivewasher assembly (12).(4) Install terminal jumper (11), terminal board assembly (10), screw (9), nut & captive washer assembly(8).(5) Install tactical relay resistor assembly (7), screw (6), nut & captive washer assembly (5).(6) Install cover(4) with screw (3).(7) Install Iockwasher (2) and screw (1).3-246