10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>TO</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-624-<strong>34</strong>c. Cleaning, Inspection, and Repair.WARNINGSolvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin,eyes and respiratory tract. Eye and skin protection required. Good general ventilationis normally adequate. Failure to observe this warning could result in servere personalinjury or death.(1) Clean relay table parts in dry cleaning solvent (Federal specification P-D-680) and dry thoroughly.(2) Inspect relay table for breaks, cracks, and other damage.(3) Check ail parts for defective paint.(4) Check all threads for crossing, stripping, and peening.(5) Repair cracks, breaks, and defective welds by welding.(6) Replace any parts damaged beyond repair.(7) Remove defective paint and corrosion. Treat and paint in accordance with service requirements.d. Installation.(1)(2)(3)(4)(5)(6)(7)(8)(9)Position left side relay table (31, figure 3–149), to install screw (30), flatwasher (29), Iockwasher (28)and nut (27).Position rear housing (24), to install screw (23), flatwasher (22), Iockwasher (21) and nut (20).Position right side relay table (26), to install screw (19),flatwasher(18), Iockwasher (17) and nut(16).Install fuel line (15).Position spacer (14), to install flatwasher (13), Iockwasher (12), and screw (11).Position top relay table (25), to install flatwasher (10), Iockwasher (9), and screw (8).Install terminal block (7), and screws (6 and 5).Install nut (4), clamp (3), Iockwasher (2) and screw (1).Refer to the Operator and Unit Maintenance Manual and install housing assembly doors, covers, andpanels.e. Installation for KZ00001 and up serial numbers(1)(2)(3)(4)(5)(6)Position top relay table (21, figure 3-1 50) to install screws (32), flatwashers (31), Iockwashers (30)and nut (29).Install grommet (28).Position Ieft side relay table (27), screw (26), flatwasher (25), Iockwasher (24) and nut (23).Install rear housing (20), screw (19), flatwasher (18), lockwasher (17) and bolt (16).Position right side relay table (22), to install screws (15), flatwasher (14), Iockwasher (13) and nut(12).Install fuel line (11).3-313

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!