ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-34Table 3-4. COMPONENT BOARD TEST VALUES(8)(9)(l0)(11)(12)d. Assembly.(1)(2)(3)(4)(5)(6)Use an ohmmeter to test resistance of relay K1 (figure 3-61). Resistance shall be 300 ± 30 ohms.Replace relay if defective.Visually inspect fault locating wiring harness connector for cracks, corrosion, and loose or damagedpins.Check individual wires for corroded or damaged terminals, burned insulation and other damage.Check individual wires for continuity using figure 3-63 as a guide.If the wiring harness has sustained damage and requires repair or rebuild, refer to figure 3-63 forlayout, identification, and material requirements and Appendix A for detailed soldering andreplacement procedures.Position housing (35) to install wiring harness (34), screw and captive washer assemblies (33).If removed, assembly cover plate assembly (items 32 through 27) for replacement of damaged partsas needed.Install cover plate assembly (26), screw and captive washer assemblies (25). Connect electricalleads and untag.If removed, assemble panel assembly (items 24 through 7) for replacement of damaged or defectivecomponents as needed.Connect electrical leads and untag. Carefully push indicator panel assembly (6) onto housing andinstall screw and captive washer assemblies (5).Install cover plate (4), screw and captive washer assemblies (3).3-140