ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-343-92. STATIC EXCITER AND VOLTAGE REGULATOR ASSEMBLY.a. General. The static exciter and voltage regulator assembly provide excitation and voltage regulation forthe generator output voltage and compares it to a reference voltage which is established by the voltage adjustrheostat on the generator set control cubicle. If difference exists, an error signal is sent to the static exciter.Excitation current supplied by the current transformer assembly is altered by the error signal until generatoroutput voltage equals the reference voltage.b. Removal.WARNINGDo not attempt to perform maintenance on the static exciter and voltage regulatorassembly while the generator set is operating. Severe electrical shock or death mayresult from failure to observe this warning.(1) Disconnect electrical connectors to static exciter and voltage regulator assembly.(2) Remove screws (1, figure 3-130) and Iockwasher (2) to remove static exciter and voltage regulatorassembly from generator set.NOTEDisassemble static exciter and voltage regulator assembly only as required to clean,inspect, test and replace components.c. Disassemblv. .(1)(2)(3)(4)(5)(6)(7)(8)(9)(10)(11)(12)(13)(14)Remove screw (3, figure 3-130), on chassis cover (4) from chassis (68).Remove nut and captive washer assembly (5), flat washer (6), screw (7) to remove heat sinkassembly (8).Remove nut and captive washer assembly (9) and screw (10).Remove wire (11), terminal lug (12), and semiconductor (13) as one assembly. Removesemiconductor (14).Remove nut and captive washer assembly (15), screws (16), heat sink (17) and heat sink support(18).Remove nut and captive washer assembly (19), screw (20), and terminal board (21).Remove nut and captive washer assembly (22), screw (23), and transformer (24).Remove nuts (25 and 26), screw (27), capacitor (28), Iockwasher (29) and bracket (30).Remove nut & captive washer assembly (31), terminal (32), and nut& captive washer assembly (33).Remove nut & captive washer assembly (34), screw (35), and transformer (36).Remove screw (37), and voltage regulator assembly (38) from chassis (68).Remove nut & captive washer assembly (39), screw (40), mounting bracket (41) and capacitor C2(42).Remove nut & captive washer assembly (43), screw (44) and transformer (45).Remove nut & captive washer assembly (46), screw (47), nut& captive washer assembly (48),Washer (49), screw (50), mica washer (51), mounting bracket (52), resistors R1 and R2 (53 and 54).3-264