ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-345-9. HEATER CONTROL ASSEMBLY.a. Removal. Refer to the Operator and Unit Maintenance Manual for heater control assembly removalinstructions.b.Disassembly.(1)(2)(3)(4)(5)(6)(7)(8)(9)(10)(11)(12)(13)(14)NOTEDisassemble heater control assembly only as required to clean, inspect, test andreplace components.Tag all electrical leads before disconnecting.Remove screws (1, figure 5-7), Iockwashers (2), and pull the panel (22) away from the Chassis (60),as far as electrical connections will allow.Remove nut (3), tooth Iockwasher (4), positioning washer (5), nut (6) and switch (7).Remove nut (8), tooth Iockwasher (9), and circuit breaker (10).Remove fuseholder (11), fuse (12), nut (13), tooth Iockwasher (14) and fuse holder (15).Remove lens (16), lamp (17), nut (18), indicator light base (19), nut (20), tooth Iockwasher (21).Remove screw and captive washer assembly (23) and cover (24).Remove screw and captive washer assembly (25), nut and captive washer assembly (26), screw andcaptive washer assemblies (27 and 28) and cushion clamp (29).Remove nut (30), flat washer (31), tooth Iockwasher (32), and semiconductor (33).Remove nut (34), flatwasher (35), Iockwasher (36) and semiconductor (37).Remove nut (38), flat washer (39), shoulder washer (40), screw & captive washer assembly (41),heat sink (42), shoulder washer (43), split grommet (44) and heat sink bracket (45).Remove screw and captive washer assembly (46), protective cap and chain (47), nut (48), screw andcaptive washer assembly (49), nut (50), and wiring harness (51).Remove nut (52), shoulder washer (53), screw (54), power relay (55) and relaly insulator (56).Remove nut (57), screw and captive washer assembly (58), and transformer (59), from chassis (60).c. Cleaning. Inspection, and Repair.WARNINGCompressed air used for cleaning and drying purpcses can create airborne particlesthat may enter the eyes. Pressure shall not exceed 30 psig and use only with adequatechip guards and chipping goggles. Failure to observe this warning could result inservere personal injury or death.WARNINGSolvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin,eyes and respiratory tract. Eyes and skin protection required. Good general ventilationis normally adequate. Failure to observe this warning could result in servere personalinjury or death.5-20