ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-34(1)(2)(3)(4)(5)(6)Clean exterior surfaces of fuel tank and other nonelectrical parts with dry cleaning solvent (FederalSpecification P-D-680).Flush interior of fuel tank with an approved solvent.Inspect fuel tank assembly for cracked or broken welds, dents, leaks, and other damage.Test fuel level sensor in accordance with instructions provided in Operator and Unit MaintenanceManual.Check filler hose for damage or deterioration.Check all threads for crossing, stripping, and peening.WARNING(7)(8)(9)c. Installion.Steam clean interior of fuel tank for a minimum of 2 hours to remove residual vaporsbefore attempting to repair welds. Serious injury or death may result from failure toobserve this warning. Failure to observe this warning could result in servere personelinjury.Repair cracks or leaks by using Epoxy. Refer to appendix Din TM 9-6115-464-12 for detailedinstructions.Repair damaged threads with a thread chaser.Replace any parts which are extensively damaged.(1) Position plastic fuel tank (17, figure 3-19) to install drain valve (16) and cap (15).(2) Install new fuel level switch gasket (14), fuel level switch (13), ground wire assembly (12),Iockwasher (11) and screws (10).(3) Position strap (9), to install flat washer (8), and locknut (7).(4) Install hose (6), filler neck (5), clamps (4), screws (3), lockwasher (2), and nut (1).(5) Refer to the Operator and Unit Maintenance Manual and accomplish the following:(a) Install lower cover panels, ventilation louver panel, and right and left ventilation doors to generatorset housing.(b) Connect enging wiring harness to fuel level gauge.(c) Connect fuel vent system to main fuel tank.(d) Connect fuel lines and fittings to main fuel tank.(e) Fill the main fuel tank assembly.3-18. FUEL TRANSFER PUMPS.NOTEInstall filler neck hose with vent holes to top and outboard.Refer to the Operator and Unit Maintenance Manual for fuel transfer pumps maintenance procedures.3-19. FUEL STRAINER AND FILTER ASSEMBLY.Refer to the Operator and Unit Maintenance Manual for fuel strainer and filter assembly maintenanceprocedures.3-45