10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-624-<strong>34</strong>1. Screw and assembled washer2. Lockwasher3. Screw and captive washer assy4. Cover plate5. Screw and captive washer assy6. Indicator panel assembly7. Nut8. Indicator light assembly9. Lens10. Lamp11. Base12. Nut13. Tooth Iockwasher14. Test or reset switch15. Capacitor16. Nut17. Positioning washer18. Nut19. Tooth Iockwasher20. Fuse holder assembly21. Cap22. Fuse23. Fuse holder24. Panel25. Screw and captive washer assy26. Cover plate assy27. Screw and captive washer assy28. Screw29. Lockwasher30. Relay31. Component board assembly32. Cover plate33. Screw and captive washer assy<strong>34</strong>. Wiring harness35. Housinge. Testing.Figure 3-60. Fault Locating Indicator, Exploded View (Sheet 2 of 2)(1) Refer to figure 3-61 and connect the positive lead of a 24 Vdc source to pin A of connector J12.(2) Connect the negative lead to pin B.(3) Place test or reset switch in the TEST or RESET position. All indicator lights shall illuminate.(4) Release test or reset switch. All indicator lights shall go dark.(5) Install a jumper between connector pins C and D. Low oil pressure indicator light shall illuminate.(6) Remove jumper from pin D. Low oil pressure indicator light shall remain lit.(7) Connect jumper between connector pins C and E and reset test or reset switch.(8) Low oil pressure indicator light shall go dark and overspeed indicator light shall illuminate.(9) Repeat steps (5) through (8) for connector pins F through N.(10) If any indicator light fails to function properly, disassemble fault locating indicator and test that portionpertinent to the malfunctioning light.f. Installation.(1) Install fault locating indicator onto generator set with Iockwashers (2, figure 3-60), and screws (l).(2) Connect wiring harness to back of fault locating indicator.3-61. MANUAL SPEED CONTROL.Refer to the Operator and Unit Maintenance Manual for manual speed control maintenance instructions.3-62. DC CONTROL CIRCUIT BREAKER.Refer to the Operator and Unit Maintenance Manual for dc control circuit breaker maintenance instructions.3-148

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!