ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-34CAUTIONDo not use press which contacts core windings. Press only on core laminations.Failure to observe this caution could result in damage to the equipment.(c)(d)(e)(f)(g)(h)(i)(j)(k)(l)(m)(n)(o)(p)(q)(r)Remove heated rotor core from oven and press onto rotor shaft until firmly seated against shoulder.Do not allow key to project more than 0.12 inch on either side of rotor.Insure exciter rotor is positioned so that lead holes are equal distant on each side of lead slot inrotor shaft.Feed field leads from generator field (18) through exciter rotor (12).Mount exciter rotor (12) onto rotor shaft and secure with Iockwashers (11) and screws (10). Torquescrews to 60 pounds-inch.NOTERemove only one diode at a time (Figure 3-139 sheet 2 of 2).Install rectifiers (13) and torque to 28 pounds-inch. Connect leads to rectifiers and solder inaccordance with established procedures.install cable clamps (7), Iockwashers (6), and screws (5).Connect electrical leads (3) and secure with Iockwashers (2) and screws(1).Install lug (4) on electrical lead (3).Temporarily install balance weights (15 and 9) and screws (14 and 8).Balance rotor and balance assembly (paragraph c. (25) above).Remove screws, Iockwashers, and weights.Coat screws with Loctite, Grade C (no known government specification) and allow to dry.Install balance weights, Iockwashers, and screws. Torque screws to 31 lb-ft.Tach weld screws and single hole weights to prevent movement.Install blower wheel (31, figure 3–136), coupling disc (30, figure 3–136), pressure plate (29), lockplate (28) with screws (27).Torque screw to 75 Ibs–ft and bend lock tab of lock plate (28) against flat of screw.(s)Using 5/8 in. bolts and nuts, temporarily fasten coupling disc to blower.(4) Assemble end bell assembly as follows:(a) Assemble exciter stator (figure 3-138) to end bell. Insuring electrical leads are lined with leadopening.(b) Secure with Iockwashers and screws.(5) Assemble generator assembly as follows:(a) Secure end bell assembly (34, figure 3-136) to stator (26) using Iockwashers (33) and screws (32).Torque screws to 31 ft-lbs.(b) Feed electrical leads through gasket (10) and insert them through loosely assembled lead block(9).3-305