ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464—34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-34e. Cleaning Inspection and Repair (Type A and B.)(1) Clean all components with cloth dampened in cleaning solvent, Federal Specification P-D-680.(2) Inspect all components for insecure mounting, loose electrical connections, cracks, corrosion andevidence of shorting or other damage.(3) Replace any parts found defective or damaged beyond repair.f. Assembly (Type A).(1)(2)(3)(4)(5)(6)(7)(8)(9)Assemble core and frame (83), coil washer (84), and coil (85).Install end plate (86) and loosely install flat washers (82), Iockwashers (81) and screws (80).Secure terminals (77) to auxiliary operator (73) with Iockwashers (76) and nuts (75).Install adhesive back spacer (78) (adhesive side up) over core and rod (79).Secure core and rod to auxiliary operator with nut (71) and Iockwasher (72).Insert guide rods (70) through auxiliary operator (73) and install return springs (74).Thread guide rods into core and frame (83) until a sufficient length extends out the bottom to looselyinstall Iockwashers (69) and nuts (68).Install the economizing switch (63) onto bracket (67) and secure with Iockwashers (62) and screws(61).Loosely secure bracket (67) to core and frame (83) with flat washers (66), Iockwashers (65) andscrews (64).(10) Fit bracket (60) over economizing switch and secure to auxiliary operator (73) with screw (59), flatwasher (58), Iockwasher (57), and nut (56).(11) Adjust assembled actuator assembly as follows: (See figure 3-102)(a)(b)(c)(d)(e)(f)(12)(13)(14)(15)Install a suitable clamp across points (A) and (B) of actuator assembly. Tighten clamp sufficiently toinsure that no air gap exists at points (C) and (D).Tighten loosely installed screws (1).Remove clamp.Insert a 0.150 ± 0.010 inch feeler gauge into the movable core gap.Adjust guide rods (2) until the gauge is snug throughout the perimeter.Secure the adjustment by tightening loosely installed nuts (3).Install contact assemblies (54 and 53, figure 3-100) and cable clamp (52) and secure with flatwasher (51), Iockwasher (50), screw (49), Iockwashers (48), and screws (47).Secure contact assemblies (38) to main base (46) with flat washers (37), Iockwashers (36), and nuts(35). Install terminal washers (41), Iockwashers (40) and nuts (39).Install grommets (33), spacers (34), and arc chutes (32).Install shims (30 and 29), springs (28), bushings (27), and shims (26) onto bridge assemblies (25).Secure bridge assemblies to main contact operator (31) with retaining rings (24).3-214