10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>TO</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-624-<strong>34</strong>3-90. SPECIAL RELAY ASSEMBLY.a.Removal.WARNINGDo not attempt to perform maintenance on the special relay assembly while thegenerator set is operating. Severe electrical shock or death may result from failure toobserve this warning.(1) Tag and disconnect electrical connectors to special relay assembly,(2) Remove screws (1, figure 3-119) and Iockwashers (2) to remove special relay assembly.b. Disassembly.NOTEDisassemble special relay assembly only as required for inspection, testing, andreplacement of components.(1) Remove screw &captive washer assembly (3, figure 3-119), cover (4) from chassis (46).(2) Remove locking nut(5), nut(6), tooth Iockwasher (7) and potentiometer (8).(3) Remove nut (9) and screw &captive washer assembly (10).(4) Remove nut (11), screw&captive washer assembly (12) and wiring harness assembly.(5) Remove nut (14), screw & captive washer assembly (15) and shorting plug (16).(6) Remove nut (17), screw and captive washer assembly (18) and protective cap assembly (19).(7) Remove nut & captive washer assembly (20), flat washer (21), and screw (22).(8) Remove nut & captive washer assembly (23) and dc relay assembly (24)(9) Remove nut & captive washer assembly (25), screw (26) and instrument shunt (27).(10) Remove nut &captive washer assembly (28), screw (29) and special current transformer (30).(11) Remove nut (31), Iockwasher (32), screw (33), cranking relay (<strong>34</strong>).(12) Remove nut & captive washer assembly (35), screw (36) and terminal board assembly (37).(13) Remove nut (38), screw & captive washer assembly (39), resistor (40) and resistor bracket assembly(41).(14) Remove nut & captive washer assembly (42), screw (43), terminal board assembly (44) and terminaljumper (45).(15) Remove resistor (47), bracket assembly (48), nut (49) and screw& captive washer assembly (50).c. Cleaning, Inspection. and Repair.WARNINGCompressed air used for cleaning and drying purposes can create airborne particlesthat may enter the eyes. Pressure shall not exceed 30 psig and use only with adequatechip guards and chipping goggles. Failure to observe this warning could result inservere personal injury or death.3-247

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!