general information - Martin Nez

3-80 ENGINE• Tighten the water pump mounting bolts to the specifiedtorque. Water pump mounting bolt: 10 N·m (1.0 kgf-m)NOTE:Pass the gear position switch lead wire 1 under the water pumplib.• Apply engine coolant to the O-ring.• Install the water inlet cover 2. Water inlet cover bolt: 10 N·m (1.0 kgf-m)GENERATOR ROTOR• Degrease the tapered portion A of generator rotor and alsothe crankshaft B. Use nonflammable cleaning solvent to wipeoff oily or greasy matter and make these surfaces completelydry.• Install the generator rotor onto the crankshaft.• Install the rotor bolt with the washer.• Hold the generator rotor with the special tool and tighten itsbolt to the specified torque. 09930-44520: Rotor holder Generator rotor bolt: 120 N·m (12.0 kgf-m)