general information - Martin Nez

3-40 ENGINECLUTCHCLUTCH DRIVE PLATES INSPECTIONNOTE:* Wipe off engine oil from the clutch drive plates with a cleanrag.* Clutch drive plate No.1: 40 friction pieces* Clutch drive plate No.2 and No.3: 48 friction piecesA Friction piece• Measure the thickness of drive plates with a vernier calipers.• If each drive plate thickness is the limit and less, replace itwith a new one. Drive plate thickness:Service Limit: 2.62 mm 09900-20102: Vernier calipers• Measure the claw width of drive plates with a vernier calipers.• Replace the drive plates found to have worn down to the limit. Drive plate claw width:Service Limit: 12.90 mm 09900-20102: Vernier calipersCLUTCH DRIVEN PLATES INSPECTIONNOTE:Wipe off engine oil from the clutch driven plates with a clean rag.• Measure each driven plate for distortion with a thicknessgauge and surface plate.• Replace driven plates which exceed the limit. Driven plate distortion (No.1 and No.2):Service Limit: 0.10 mm 09900-20803: Thickness gaugeCLUTCH SPRING INSPECTION• Measure the free length of each coil spring with a vernier calipers,and compare the length with the specified limit.• Replace all the springs if any spring is not within the limit. Clutch spring free length:Service Limit: 52.4 mm 09900-20102: Vernier calipers