general information - Martin Nez

10-2 SERVICING INFORMATIONTROUBLESHOOTINGFI SYSTEM MALFUNCTION CODE AND DEFECTIVE CONDITIONDTC No.DETECTEDITEMDETECTED FAILURE CONDITIONCHECK FORC00 NO FAULT ––––––––––– –––––––––––C11P0340signal.CMP sensor, intake cam pin,wiring/coupler connectionCMP sensor The signal does not reach ECM for 3 CMP sensor wiring and mechanicalsec. or more, after receiving the starter partsC12P0335C13P0105C14P0120C15P0115HLHLHLCKP sensor The signal does not reach ECM for 3sec. or more, after receiving the startersignal.IAP sensorTP sensorECT sensorThe sensor should produce followingvoltage.0.5 V sensor voltage < 4.85 VIn other than the above range, C13(P0105) is indicated.Sensor voltage is higher than specifiedvalue.Sensor voltage is lower than specifiedvalue.The sensor should produce followingvoltage.0.2 V sensor voltage < 4.80 VIn other than the above range, C14(P0120) is indicated.Sensor voltage is higher than specifiedvalue.Sensor voltage is lower than specifiedvalue.The sensor voltage should be the following.0.15 V sensor voltage < 4.85 VIn other than the above range, C15(P0115) is indicated.Sensor voltage is higher than specifiedvalue.Sensor voltage is lower than specifiedvalue.CKP sensor wiring and mechanicalpartsCKP sensor, lead wire/couplerconnectionIAP sensor, lead wire/couplerconnectionIAP sensor circuit shorted toVCC or ground circuit openIAP sensor circuit open orshorted to ground or VCC circuitopenTP sensor, lead wire/couplerconnectionTP sensor circuit shorted toVCC or ground circuit openTP sensor circuit open orshorted to ground or VCC circuitopenECT sensor, lead wire/couplerconnectionECT sensor circuit open orground circuit openECT sensor circuit shorted toground