general information - Martin Nez

8-46 CHASSISINSPECTION AND DISASSEMBLYSPACER• Remove the collars and spacer from swingarm.• Remove the dust seals and spacers from the cushion lever.• Inspect the collars and spacers for any flaws or other damage.If any defects are found, replace the collars or spacerwith a new one.SWINGARM BEARINGInsert the collars and spacer into bearings and check the playwhen moving the collars and spacer up and down.If excessive play is noted, replace the bearing with a new one.• Draw out the swingarm pivot bearings 1 and the swingarmcushion rod upper bearings 2 with the special tool. 09921-20240: Bearing remover set (1 28 mm)(2 17 mm)The removed bearings must be replaced with the newones.