10.07.2015 Views

general information - Martin Nez

general information - Martin Nez

general information - Martin Nez

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

SERVICING INFORMATION 10-17WIRING HARNESS, CABLE AND HOSE ROUTINGWIRING HARNESS ROUTINGSpeedometerHandlebar switch-RH*1#1 InjectorFWD*3#2 InjectorDelivery pipe*2PAIR solenoidvalve bracket*5*4Taping clampReservoir tank Starter motor ClampSet couplersSpeed sensorinsideClamp atwhite tape.Oil pressure switchBrake lightWiring harness*620mmClamp10mmHandlebar switch-LHHeadlightThrottlecableTapingclampBandTaping clampWiring Wiring harnes (to FP relay)harnessOil pressure switchClutch cableOil pressureswitchBrake light switchSpeed sensorMagnetoTurn-LH5mmReservoir tankStop lamp switchSignal generator Battery lead wire8 N·m (0.8 kgf-m) Starter motorlead wire5–10 mm5–10 mmCKP sensormax 3 mmCushionImmobilizer label5–10 mmUnder ECM*1*2*3Set the starter motor lead wire between radiatorinlet hose and reservoir tank.Pass the handle switch-RH left side of PAIRsolenoid valve bracket.Pass the IAT sensor branch wire under the deliverypipe.*4 Cut after clamping and set the lock part downward.*5 Do not twist the lead wires.*6Pass through the brake light switch lead wireavobe the rear brake reservoir tank hose.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!