general information - Martin Nez

3-92 ENGINECYLINDER HEAD• Fit the dowel pins 1 and new cylinder head gasket 2 to thecylinder.Use new gasket to prevent gas leakage.• Place the cylinder head on the cylinder.NOTE:When installing the cylinder head, keep the cam chain taut.• Tighten the cylinder head bolts (M10) in the followingfour-step.Step 1:• Tighten the cylinder head bolts to the specified torque with atorque wrench sequentially and diagonally.Step 2:• Loosen all the cylinder head bolts diagonally.Step 3:• Retighten the cylinder head bolts to the specified torque witha torque wrench sequentially and diagonally.Step 4:• Tighten the cylinder head bolts to the specified angles diagonallywith an angular torque gauge. Cylinder head bolt (M10): Step 1/Step 3: 31 N·m (3.1 kgf-m)Final Step: 60°NOTE:Apply engine oil to the washers and thread portion of the boltsbefore installing the cylinder head bolts.• Tighten the cylinder head bolts to the specified torque. Cylinder head bolt (M6): 10 N·m (1.0 kgf-m)Cylinder head side face bolt: 14 N·m (1.4 kgf-m)