general information - Martin Nez

FUEL SYSTEM AND THROTTLE BODY 5-17THROTTLE BODY REASSEMBLYReassemble the throttle body in the reverse order of disassembly.Pay attention to the following points:• With the STV fully opened, install the STP sensor 1 andtighten the STP sensor mounting screw to the specifiedtorque.NOTE:* Apply thin coat of engine oil to the O-ring.* Align the secondary throttle shaft end A with the groove B ofSTP sensor.* Apply SUZUKI SUPER GREASE “A” to the secondary throttleshaft end A if necessary. 99000-25010: SUZUKI SUPER GREASE “A”(or equivalent grease) 09930-11950: Torx wrench STP sensor mounting screw: 3.5 N·m (0.35 kgf-m)NOTE:* Make sure the STV open or close smoothly.* If the STP sensor adjustment is necessary, refer to page 5-20for STP sensor setting procedure.• With the throttle valve fully closed, install the TP sensor 2and tighten the TP sensor mounting screw to the specifiedtorque.NOTE:* Apply thin coat of engine oil to the O-ring.* Align the throttle shaft end C with the groove D of TP sensor.* Apply SUZUKI SUPER GREASE “A” to the throttle shaft endC if necessary. 99000-25010: SUZUKI SUPER GREASE “A”(or equivalent grease) 09930-11950: Torx wrench TP sensor mounting screw: 3.5 N·m (0.35 kgf-m)NOTE:* Make sure the throttle valve open or close smoothly.* TP sensor setting procedure. (4-19)