10.07.2015 Views

general information - Martin Nez

general information - Martin Nez

general information - Martin Nez

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

7-10 COOLING AND LUBRICATION SYSTEM• Keep on heating the water to raise its temperature.• Just when the water temperature reaches specified value, thethermostat valve should have lifted by at least 8 mm. Thermostat valve lift AStandard: 8.0 mm and over at 95 °C• A thermostat failing to satisfy either of the two requirements(start-to-open temperature and valve lift) must be replaced.INSTALLATION• Install the thermostat.NOTE:The jiggle valve A of the thermostat faces upside.• Install the thermostat cover 1.• Tighten the thermostat cover bolts to the specified torque. Thermostat cover bolt: 10 N·m (1.0 kgf-m)• Pour engine coolant and bleed air from the cooling circuit.(2-17 and -18)

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!