general information - Martin Nez

9-16 ELECTRICAL SYSTEM• Align the marks on the housing ends with the marks on thestarter motor case.• Apply SUZUKI SUPER GREASE “A” to the O-ring. 99000-25010: SUZUKI SUPER GREASE “A”(or equivalent grease)STARTER MOTOR INSTALLATION• Tighten the starter motor lead wire connecting nut 1 to thespecified torque. Lead wire connecting nut: 6 N·m (0.6 kgf-m)STARTER RELAY INSPECTION• Remove the seat. (8-3)• Disconnect the battery - lead wire from the battery.• Remove the starter relay cover.• Disconnect the starter motor lead wire 1, battery lead wire 2and starter relay coupler 3.• Remove the starter relay.• Apply 12 V to A and B terminals and check for continuitybetween the positive and negative terminals using themulti-circuit tester. If the starter relay clicks and continuity isfound, the relay is ok. 09900-25008: Multi-circuit tester set Tester knob indication: Continuity test ()Do not apply battery voltage to the starter relay formore than five seconds, since the relay coil may overheatand get damaged.