general information - Martin Nez

ELECTRICAL SYSTEM 9-27CKP SENSOR PEAK VOLTAGE• Remove the seat. (8-3)NOTE:Be sure that all couplers are connected properly and the batteryused is in fully-charged condition.• Disconnect the both ECM couplers 1.• Connect the multi-circuit tester with peak volt adaptor as follows.• Measure the CKP sensor peak voltage between G/B andGreen/White lead wires at the ECM coupler.G/W wire (+ Probe) – G/Bl wire (- Probe) 09900-25008: Multi-circuit tester set09900-25009: Needle pointed probe setBefore using the multi-circuit tester and peak voltadaptor, be sure to refer to the appropriate instructionmanual.G/WG/Bl• Shift the transmission into the neutral and turn ignition switchto ON.• Crank the engine a few seconds with the starter motor bydepressing starter button and check the CKP sensor peakvoltage.• Repeat the above test procedure a few times and measurethe highest peak voltage. Tester knob indication: Voltage () CKP sensor peak voltage: 0.5 V and more(G/Bl – G/W)CKP sensorcouplerG/Bl G/WG/W WCKP sensorECMcouplerPeakvoltadaptor