general information - Martin Nez

10-4 SERVICING INFORMATIONDTC No.C29P1654C31P0705C32/C33C34/C35HLP0201/P0202P0203/P0204C41P0230C42P1650HLDETECTEDITEMSTP sensorGear positionsignalFuel injectorFuel pumprelayIgnitionswitchDETECTED FAILURE CONDITIONThe sensor should produce followingvoltage.0.15 V sensor voltage < 4.85 VIn other than the above range, C29(P1654) is indicated.Sensor voltage is higher than specifiedvalue.Sensor voltage is lower than specifiedvalue.Gear position signal voltage should behigher than the following for 3 secondsand more.Gear position sensor voltage > 0.6 VIf lower than the above value, C31(P0705) is indicated.CKP sensor (pickup coil) signal is produced,but fuel injector signal is interrupted4 times or more continuously. Inthis case, the code C32 (P0201), C33(P0202), C34 (P0203) or C35 (P0204)is indicated.No voltage is applied to the fuel pump,although fuel pump relay is turned ON,or voltage is applied to fuel pumpalthough fuel pump relay is turnedOFF.Voltage is applied to fuel pumpalthough fuel pump relay is turnedOFF.No voltage is applied to the fuel pump,although fuel pump relay is turned ON.Ignition switch signal is not input to theECM.When the ID agreement is not verified.ECM does not receive communicationsignal from the immobilizer antenna.CHECK FORSTP sensor, lead wire/couplerconnectionSTP sensor circuit shorted toVCC or ground circuit openSTP sensor circuit open orshorted to ground or VCC circuitopenGP switch, wiring/coupler connection,gearshift cam, etc.Fuel injector, wiring/coupler connection,power supply to theinjectorFuel pump relay, lead wire/couplerconnection, power source tofuel pump relay and fuel injectorsFuel pump relay switch circuitshorted to power source.Fuel pump relay (switch side)Fuel pump relay circuit open orshortFuel pump relay (coil side)Ignition switch, lead wire/coupler,etc.Immobilizer/anti-theft system