general information - Martin Nez

9-18 ELECTRICAL SYSTEMGEAR POSITION SWITCH• Disconnect the gear position switch coupler 1 and check thecontinuity between Bl and B/W with the transmission in neutral. 09900-25008: Multi-circuit tester set Tester knob indication: Continuity test ()ON (Neutral)OFF (Except neutral)BlB/WWhen disconnecting and connecting the gear positionswitch coupler, make sure to turn OFF the ignitionswitch, or electronic parts may get damaged.• Connect the gear position switch coupler to the wiring harness.• Turn the ignition switch to ON position and side-stand toupright position.• Measure the voltage between P and B/W lead wires using themulti-circuit tester when shifting the gearshift lever from low totop. 09900-25008: Multi-circuit tester set09900-25009: Needle pointed probe set Tester knob indication: Voltage () Gear position switch voltage: 0.6 V and more* Low to top gear position (P + – B/W -)* Except neutral position (P + – B/W -)VUse the special tool, to prevent the rubber of the waterproof coupler from damage.