general information - Martin Nez

CHASSIS 8-51• Assemble the cushion rods 1 to the swingarm temporarily.NOTE:* The stamped marks A on the cushion rods should face outside.* The bolt should be inserted from left side.• Install the chain buffer 2, chain case 3 and rear fender(lower) 4.INSTALLATIONInstall the swingarm in the reverse order of removal. Pay attentionto the following points:SWINGARM PIVOT THRUST CLEARANCE ADJUSTMENTAdjust swingarm pivot thrust clearance in the following procedure.• Insert the swingarm pivot shaft and tighten its to the specifiedtorque. 09900-18740: Hexagon socket (24 mm) Swingarm pivot shaft: 15 N·m (1.5 kgf-m)• Hold the swingarm pivot shaft and tighten the swingarm pivotnut 1 to the specified torque. Swingarm pivot nut: 100 N·m (10.0 kgf-m)• Tighten the swingarm pivot lock-nut to the specified torquewith the special tool. 09940-14940: Swingarm pivot thrust adjuster socketwrench Swingarm pivot lock-nut: 90 N·m (9.0 kgf-m)