general information - Martin Nez

3-84 ENGINESTARTER CLUTCH• Install the washer 1.• Install the starter clutch assembly onto the crankshaft.NOTE:When installing the starter clutch assembly, align the wide splineteeth A and B.• Install the starter clutch bolt with the washer.• Hold the starter clutch with the special tool and tighten its boltto the specified torque. 09920-34830: Starter clutch holder Starter clutch bolt: 54 N·m (5.4 kgf-m)STARTER IDLE GEAR• Install the starter idle gear No.2 1, its shaft 2 and concavedwasher 3.• Apply SUZUKI BOND lightly to the mating surfaces A at theparting line between the upper and middle crankcases andsurface B as shown. 99000-31140: SUZUKI BOND “1207B”• Install new gasket 4 and dowel pins 5.Use a new gasket to prevent oil leakage.