Download complete manual - pdf - Xtreme Manufacturing

EngineXR620/621/842/1045/1245/1254/1267/1534/2050/30345-17 CHECK ENGINE HOSES AND CONNECTIONSEVERY 500 HOURS OFOPERATIONPerform the following procedure to check the engine hoses, tubing, and connections for leaks, damage,and tightness:PersonnelSpecial tools and equipment– TASK REQUIREMENTS –One mechanicSafety glassesDrop lightParts and consumable materials Danger tags (2)INITIAL SET-UP1. Park forklift on level surface.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage. Allow sufficient space to open forklift covers.5. Set Ignition switch to OFF.6. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.INSPECTION1. Open engine cover (Figure 1-2).2. Inspect engine hoses, tubing, and connections for the following defects:• Evidence of leakage.• Loose or corroded clamps.• Bulges.• Cracks.• Cuts.• Soft or mushy spots.• Hard spots.3. Replace any defective hoses, tubing, or clamps.4. Check system for leaks.Service Manual Rev 01 – 05/10 5-29P/N 24933-000