Download complete manual - pdf - Xtreme Manufacturing

Transmission, Axles & DriveshaftsXR620/621/842/1045/1245/1254/1267/1534/2050/3034Section 6Transmission, Axles, & Driveshafts6-1 GENERAL MAINTENANCE SAFETYUse caution when performing maintenance on the forklift. Wear personalprotective equipment when appropriate and use danger tags. Carefully follow themaintenance procedures provided in this chapter. Read the Material Safety DataSheets (MSDS) for solvents, cleaners, etc. Read and fully understand the safetyinformation provided in Chapter 2 – Maintenance & Operation Safety, beforeperforming maintenance on the forklift.6-2 USING A GREASE GUNThe following is a general procedure to follow when lubricating grease fittings:Use caution when loading grease into the gun to ensure that contaminants are notintroduced into the grease. If using a cartridge, be careful when removing themetal lid to prevent metal slivers from being introduced into the grease.1. Load grease gun with extreme pressure, NLGI #2 grease.Dirt and other contaminants in the grease can cause premature failure of thebearing. Ensure that grease fitting and grease gun nozzle are clean.2. Clean dispensing nozzle of grease gun with clean cloth.3. Pump small amount of grease out of dispensing nozzle to ensure that fresh, clean grease will beused.4. Clean grease fitting with clean cloth.Service Manual Rev 01 – 05/10 6-1P/N 24933-000