Download complete manual - pdf - Xtreme Manufacturing

Transmission, Axles & DriveshaftsXR620/621/842/1045/1245/1254/1267/1534/2050/30342. Slowly loosen fill/drain plug and remove from wheel-end.3. Inspect fill/drain plug for dirt and damaged threads. Clean, repair, and replace as required.4. Inspect fill/drain port threads for damage. Repair as required.5. Check fluid level in wheel-end. Fluid should be at bottom of drain port hole (Figure 6-6).6. If fluid level is low, proceed to Step 7. If fluid level is OK, proceed to Step 9.7. Place spout of clean funnel in wheel-end fill/drain port. Recommend using funnel that has flexiblespout.8. Slowly pour oil into wheel-end fill/drain port through funnel until oil comes up to bottom of port hole.9. Install fill/drain plug in port and tighten finger-tight.10. Torque fill/drain plug to 44 ft-lbs.11. Perform above procedure for three remaining axle wheel-ends.Figure 6-5. Axle Wheel EndService Manual Rev 01 – 05/10 6-12P/N 24933-000