Download complete manual - pdf - Xtreme Manufacturing

Storage & TransportationXR620/621/842/1045/1245/1254/1267/1534/2050/30345. If POWERPART Lay-Up 2 is not available, use a preservative of the correct specification instead oflubricating oil. If a preservative is used, this must be drained completely at end of the storage periodand oil pan must be refilled to correct level with normal lubricating oil.6. Operate engine for short period of time to circulate oil. Check for leaks.COOLING SYSTEMDo not drain coolant while engine is still hot and the system is under pressurebecause dangerous hot coolant can be discharged.1. Remove filler cap of cooling system.2. Remove drain plug from the side of cylinder block in order to drain engine. Ensure that drain hole isnot restricted.3. Place container beneath radiator drain plug.4. Open radiator drain plug to drain radiator.5. Flush cooling system with clean water.6. Re-install drain plugs and filler cap.7. Close radiator drain plug.8. Fill cooling system with 50% ethylene glycol / 50% water mixture. Note that this mixture providesprotection against corrosion.9. Operate engine for short period in order to circulate coolant in engine.BATTERY1. Check battery condition indicator. Battery should be fully charged before being placed in storage.2. Disconnect cables from battery.3. Clean battery terminals and coat with POWERPART Lay-Up 3.4. Put battery into safe storage.FUEL INJECTION SYSTEM1. Clean engine breather pipe and seal end of pipe with waterproof tape.2. Remove fuel injector nozzles and spray POWERPART Lay-Up 2 for one or two seconds into eachcylinder bore with piston at bottom dead center.3. Slowly turn crankshaft for one complete revolution and then re-install fuel injector nozzles.AIR INDUCTION SYSTEM1. Remove air filter assembly.2. If necessary, remove pipes that are installed between air filter assembly and turbocharger.Service Manual Rev 01 – 05/10 12-3P/N 24933-000