Download complete manual - pdf - Xtreme Manufacturing

Electrical SystemXR620/621/842/1045/1245/1254/1267/1534/2050/3034REPLACE FUSE1. Open battery compartment cover.2. Set Battery Disconnect switch (Figure 9-8) to OFF.3. Remove three screws and washers from hinged console access panel (see Figure 9-5).4. Gently lower console access panel to gain access to electrical center.5. Refer to Table 9-1 and Figure 9-5 for description and location of fuses.6. Locate relay to be removed.7. Gently rock fuse back and while applying upward pressure until fuse releases from socket.8. Inspect fuse to determine if defective (Figure 9-9).9. Install new fuse in socket.10. Reconnect black battery cable to negative (-) battery terminal.11. Start engine and check out system and or component protected by fuse.12. Set Ignition switch to OFF.13. Raise console access panel and secure with three screws and washers.14. Close battery compartment cover.Figure 9-9. Determining Fuse ConditionService Manual Rev 01 – 05/10 9-21P/N 24933-000