Download complete manual - pdf - Xtreme Manufacturing

Boom & AttachmentsXR620/621/842/1045/1245/1254/1267/1534/2050/3034Be very careful when working near moving boom parts and the chain. Seriousinjuries may result when fingers or loose clothing get caught in moving chain orboom components.INITIAL SET-UP1. Park forklift on level surface.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage to ground.5. Set Ignition switch to OFF.6. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.INSPECTION1. Inspect slide blocks (Figure 10-8, Sheet 2) for following defects:• Looseness.• Cracks or other damage.• Excessive wear.• Missing screws and washers.• Corrosion and dirt.2. Correct any defects found during inspection. If a screw is loose, remove screw and clean threads.Apply Loctite Blue 242® to portion of screw threads that engage with slide block nut and re-installscrew.3. If any single slide block must be replaced, replace all the slide blocks at the location. Refer to para.10-9 for replacement procedure.Service Manual Rev 01 – 05/10 10-17P/N 24933-000