Download complete manual - pdf - Xtreme Manufacturing

Hydraulic SystemXR620/621/842/1045/1245/1254/1267/1534/2050/3034INITIAL SET-UP1. Park forklift on level surface.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage. Allow sufficient space to open forklift covers.5. Set Ignition switch to OFF.REPLACE AIR BREATHER1. Carefully clean area around air breather fitting (Figure 8-7) to prevent contamination of reservoir.2. Remove air breather from reservoir. If air breather cannot be removed by hand, loosen with a strapwrench.3. Install new air breather on fitting and hand tighten. DO NOT use strap wrench to tighten filter.4. Start engine and check for leaks at air breather.5. Check operation of hydraulic system.Figure 8-7. Air BreatherService Manual Rev 01 – 05/10 8-15P/N 24933-000