Download complete manual - pdf - Xtreme Manufacturing

Hydraulic SystemXR620/621/842/1045/1245/1254/1267/1534/2050/3034REPLACE FILTER1. Open front cover (Figure 1-2) to gain access to return line filter (Figure 8-8).2. Place container beneath return line filter.3. Clean area around filter to prevent contaminants from entering system.Filter may be full of hot hydraulic fluid.4. Use strap wrench or filter wrench to remove filter from distribution manifold (Figure 8-10). Allowhydraulic fluid to drain into container.5. Dispose of fluid and filter properly.6. Lubricate new O-ring with hydraulic fluid and install on filter.DO NOT torque the filter. Hand tighten only.7. Screw filter on to distribution manifold and hand tighten until O-ring contacts sealing surface, thentighten 3/4 turn.8. Start engine and run until warm.9. Check for leaks at filter. Hand tighten filter further if necessary.Figure 8-10. Return Line FilterService Manual Rev 01 – 05/10 8-20P/N 24933-000