Download complete manual - pdf - Xtreme Manufacturing

Transmission, Axles & DriveshaftsXR620/621/842/1045/1245/1254/1267/1534/2050/30343. Inspect fill/drain plug for dirt and damaged threads. Clean, repair, and replace as required.4. Inspect fill/drain port threads for damage. Repair as required.5. Position container beneath fill/drain port.6. Slowly loosen fill/drain plug and remove from wheel-end.7. Allow oil to drain completely into container.8. Move forklift until wheel-end drain plug is at 3 o'clock position.9. Place spout of clean funnel in wheel-end fill/drain port. Recommend using funnel that has flexiblespout.10. Slowly pour oil into wheel-end fill/drain port through funnel until oil comes up to bottom of port hole.11. Install fill/drain plug in port and tighten finger-tight.12. Torque fill/drain plug to 44 ft-lbs.13. Perform above procedure for three remaining axle wheel-ends.Service Manual Rev 01 – 05/10 6-14P/N 24933-000