Download complete manual - pdf - Xtreme Manufacturing

Maintenance & Operation SafetyXR620/621/842/1045/1245/1254/1267/1534/2050/3034– Depress the Service Brake pedal after the forklift begins to move. The forklift should stopimmediately.– Set the Parking Brake switch to ON. The forklift should not move unless the Parking Brake switchis set to OFF. Test each steering function. Operate the forklift in forward and reverse at low idle speed and turn thesteering wheel approximately ¼ turn in each direction.– Align the wheels and set the steering select switch to crab steering.– Align the wheels and set the Steering Select switch to 2 wheel (2W) steering.– Align the wheels and set the Steering Select switch to 4 wheel (4W) steering.Check gauges after the engine warms to the proper operating range. Check the Volts gauge. The voltage gauge should read between 11 to 15 Volts. Check the Coolant temperature gauge. The engine coolant temperature gauge should read between180 to 200°F. Check the Oil pressure gauge. The engine oil pressure gauge should read between 40 to 80 psi. Check the Fuel gauge and make sure the fuel gauge reads between ½ to full. Fill the fuel tank if theFuel gauge shows less than ½ full.2-16 LOAD HANDLING• Injury or death by electrocution can result from contact with or inadequateclearance with energized power lines or apparatus.• NEVER operate the forklift in an area where active overhead power lines,overhead or underground cables, or other power sources exist.• Contact the appropriate power or utility company to de-energize power lines ortake other suitable precautions.• Keep the forklift, attachments, and loads a safe distance from electrical powerlines.• Stay clear of power lines. Contact with power lines will cause death or severeinjury. DO NOT allow forklift or load within 10 feet (3 meters) plus 2 times theline insulator length of any power line. Notify the power company to de-energizethe power lines before operating the forklift near the power lines.• Worksite operating directives and/or local or state codes might require a greaterdistance.• Know the maximum height and reach of this reach forklift.Service Manual Rev 01 – 05/10 2-14P/N 24933-000