Download complete manual - pdf - Xtreme Manufacturing

Transmission, Axles & DriveshaftsXR620/621/842/1045/1245/1254/1267/1534/2050/30346-7 CHECK WHEEL-END OIL LEVELEVERY 250 HOURS OFOPERATIONPerform the following procedure to check the wheel-end oil level and add oil if required:PersonnelSpecial tools and equipment– TASK REQUIREMENTS –One mechanicTorque wrenchBrushFunnel with flexible spoutParts and consumable materials Danger tags (2)O-ringClean clothSafety solventOil, SAE 80W-90 EP API GL4Oil, SAE 80W-90 EP API GL5There are two different axles that may be installed on Model XR1045/1245/1254forklifts. These axles have different lubrication requirements. One axle requiresSAE 80W-90 EP API GL4 Oil, the other axle requires SAE 80W-90 EP API GL5 Oil.Always check the axle data plate to determine the correct lubricant and quantityrequired.INITIAL SET-UP1. Move forklift to a level surface.2. Move forklift backward and/or forward until wheel-end drain plug is at 3 o’clock position (Figure 6-6).3. Set Travel Select lever to NEUTRAL (N).4. Set Parking Brake switch to ON.5. Retract boom and lower carriage. Allow sufficient space to open forklift covers.6. Set Ignition switch to OFF.7. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.CHECK/FILL WHEEL-END1. Clean area around wheel-end fill/drain plug with brush, solvent, and clean cloth.Service Manual Rev 01 – 05/10 6-11P/N 24933-000