Download complete manual - pdf - Xtreme Manufacturing

Hydraulic SystemXR620/621/842/1045/1245/1254/1267/1534/2050/30348-6 CHECK HYDRAULIC FLUID LEVELEVERY 8 HOURS OFOPERATIONPerform the following procedure to check the hydraulic fluid level and add fluid if required:CHECK FLUID LEVELCheck sight gauge on side of hydraulic reservoir (Figure 8-3). Fluid level should be at mid-point on gauge.If fluid level is low, refer to ADD FLUID procedure below.ADD FLUID– TASK REQUIREMENTS –PersonnelSpecial tools and equipmentParts and consumable materialsOne mechanicSafety glassesHex key wrench, 3/4"FunnelDanger tagsHydraulic fluid, Dexron III(AW46 for older units with clear fluid)Safety solventBrushLint-free wiping cloths or clean clothINITIAL SET-UP1. Park forklift on level surface.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage. Allow sufficient space to open forklift covers.5. Set Ignition switch to OFF.6. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.7. Relieve hydraulic system pressure as follows:a. Remove air breather from reservoir. Be careful to prevent contamination of air breather orreservoir fittings.b. Depress pressure relief valve in center of reservoir air breather fitting.Service Manual Rev 01 – 05/10 8-6P/N 24933-000