Download complete manual - pdf - Xtreme Manufacturing

Hydraulic SystemXR620/621/842/1045/1245/1254/1267/1534/2050/3034ADD FLUID – FILLER CAPFigure 8-3. Hydraulic Reservoir Sight GaugeContaminated hydraulic fluid can severely damage hydraulic system components anddegrade performance. Ensure that filler cap and pipe are clean to prevent contaminantsfrom entering reservoir when fluid is added to tank.NOTE: Some early forklift models have lockable, filler caps used for adding hydraulicfluid. Late model forklifts have a plug installed in the filler/breather plate.1. Inspect filler cap (Figure 8-4) and surrounding area for dirt and debris. Clean as required.2. Unlock filler cap and lift cap.3. Add fluid to reservoir until fluid level reaches midpoint on sight gauge.4. Close and lock filler cap.ADD FLUID – PLUG1. Inspect plug (Figure 8-4) and surrounding area for dirt and debris. Clean as required.2. Remove plug with adjustable wrench or 3/4" hex key wrench. Remove O-ring.3. Add fluid to reservoir until fluid level reaches midpoint on sight gauge.4. Install O-ring and plug in filler/breather plate and tighten.Service Manual Rev 01 – 05/10 8-7P/N 24933-000