Download complete manual - pdf - Xtreme Manufacturing

Electrical SystemXR620/621/842/1045/1245/1254/1267/1534/2050/30349-8 INSTALL AUXILIARY BATTERYPerform the following procedure to install an auxiliary battery:PersonnelSpecial tools and equipment– TASK REQUIREMENTS –One mechanicSafety glassesRubber glovesParts and consumable materials Danger tags (2)12-volt batteryAuxiliary battery cable (positive)Auxiliary battery cable (negative)Battery hold-downJ-bolt (2)Wing nut (2)DO NOT begin this maintenance procedure without first reading andunderstanding para. 9-2, Battery Safety.INITIAL SET-UP1. Park forklift on level surface.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage. Allow sufficient space to open forklift covers.5. Set Ignition switch to OFF.6. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.INSTALLATION1. Place battery in auxiliary battery mount (Figure 9-3).2. Insert curved end of J-bolts in mount holes.3. Position battery hold-down on top of battery and over J-bolts and attach with wing nuts.Service Manual Rev 01 – 05/10 9-9P/N 24933-000