Download complete manual - pdf - Xtreme Manufacturing

EngineXR620/621/842/1045/1245/1254/1267/1534/2050/3034Special tools and equipmentSafety glassesTorque wrenchFunnelContainerParts and consumable materials Danger tags (2)Oil, 15W-40 API CG4 (8 qts)(See Figure 5-7 for additional info.)INITIAL SET-UP1. Park forklift on level surface. This will help ensure an accurate reading on dipstick.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage. Allow sufficient space to open forklift covers.5. Operate engine until warm.6. Set Ignition switch to OFF.7. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.Do not exceed the correct level of engine oil. An excess of engine oil could enterthe breather valve. This could cause the engine speed to increase rapidly withoutcontrol.Discard the used engine oil in a safe place and in accordance with localregulations.DRAIN AND FILL CRANKCASE1. Open engine cover (Figure 1-2).2. Place container below engine oil pan.3. See Figure 5-6. Remove oil pan drain plug (1) and O-ring.4. Drain engine oil into container.5. Ensure O-ring is not damaged. Install drain plug and O-ring. Torque drain plug to 25 ft-lbs.6. Add approximately 8 quarts of oil to crankcase until oil level reaches fill line on dipstick (2).7. Remove container and properly dispose of engine oil.8. Start engine and check for oil leaks.Service Manual Rev 01 – 05/10 5-11P/N 24933-000