Download complete manual - pdf - Xtreme Manufacturing

Hydraulic SystemXR620/621/842/1045/1245/1254/1267/1534/2050/30344. Use wrench to remove filter bowl from filter body. Allow hydraulic fluid to drain into container.5. Remove filter element from filter bowl and dispose of properly.6. Coat new filter bowl O-ring with hydraulic fluid and install in filter bowl.7. Coat new filter head seal with hydraulic fluid and install in filter head.8. Insert new filter element inside filter bowl.Special care is required when screwing filter bowl into filter to prevent crossthreading. DO NOT torque the filter bowl. Hand tighten only.9. Screw filter bowl onto filter head until O-ring contacts sealing surface, then tighten 3/4 turn.10. Start engine and run until warm.11. Check for leaks at filter. Hand tighten filter further if necessary.Figure 8-9. High-Pressure FilterService Manual Rev 01 – 05/10 8-18P/N 24933-000