Download complete manual - pdf - Xtreme Manufacturing

Storage & TransportationXR620/621/842/1045/1245/1254/1267/1534/2050/30343. Top off front and rear axle oil.4. Wash and wax the exterior finish.5. Apply rust-inhibiting lubricant to all exposed cylinder rods.6. Apply protectant to tires.7. Apply protectant to operator seat.8. Seal tail pipe with waterproof tape to prevent entry in exhaust system by rodents, etc.9. If the forklift will be in storage for a year or more, support it on jack stands or blocks. This will takethe weight off of the wheel bearings.10. Remove wheels and tires and store them flat and out of the sunlight.11. If possible, store forklift indoors where it will be protected from adverse weather.12. If forklift is to be stored outside, park it on concrete or asphalt, or wood planks laid out over dirt.Cover forklift with a tarp.12-4 TRANSPORTING FORKLIFTRefer to Table 12-1 for forklift operating weights and see Figure 12-1 for the location of forklift tie-downpoints.Xtreme Manufacturing is not responsible for any aspect of forklift transportation.The owner/operator assumes full responsibility for:• Choosing the proper method of transportation.• Choosing the proper tie-down devices.• Ensuring the equipment used is capable of supporting the weight of theforklift being transported.• Ensuring that Department of Transportation and other federal or statelaws and regulations are followed.• Ensuring that all safety rules of their employer are followed.• Ensuring that all manufacturer's instructions and warnings are followed.Table 12-1. Forklift Operating WeightsForklift ModelOperating Weight (Lbs.)XR620/621 12,700XR842 26,850XR1045 27,130XR1245 32,930Service Manual Rev 01 – 05/10 12-5P/N 24933-000