Download complete manual - pdf - Xtreme Manufacturing

Checkout ProceduresXR620/621/842/1045/1245/1254/1267/1534/2050/30348. Park forklift on level surface.9. Retract boom.10. Raise boom and then lower until boom is horizontal (level) to ground. Verify Boom Angle indicatorreads 0 degrees.11. Retract outriggers (if equipped).12. Use Frame Sway control to level frame.13. Verify Rear Axle Locked indicator is OFF.14. Use Frame Sway control to sway frame full left. Verify Frame Level (slope) indicator (Figure 11-2)displays 11 degrees left.15. Use Frame Sway control to sway frame full right. Verify Frame Level (slope) indicator displays 11degrees right.16. Use Frame Sway control to level forklift. Verify Frame Level (slope) indicator displays 0 degrees.17. Drive forklift up on 8" X 8" wood block located in front of left front wheel and depress service brakepedal.18. Set Travel Select lever to NEUTRAL (N).19. Raise boom to 40 degrees. The Rear Axle Locked light must come ON and remain on.NOTE: In the following step, observe and record the actual boom angle at which theRear Axle Locked light comes on.20. With Service Brake pedal depressed and Parking Brake switch set to OFF, set Travel Select lever toNEUTRAL (N) and raise the boom to 40 degrees.Figure 11-1. Boom Angle IndicatorService Manual Rev 01 – 05/10 11-2P/N 24933-000