Download complete manual - pdf - Xtreme Manufacturing

Maintenance & Operation SafetyXR620/621/842/1045/1245/1254/1267/1534/2050/3034necessary to come into contact with components which have been burnt, ensure that theprecautions which follow are used:• Ensure that the components have cooled.• Use neoprene gloves and discard the gloves safely after use.• Wash the area with calcium hydroxide solution and then with clean water.• Disposal of components and gloves which are contaminated must be inaccordance with local regulations.If there is contamination of the skin or eyes, wash the affected area with a continuous supply ofclean water or with calcium hydroxide solution for 15-60 minutes. Obtain immediate medicalattention.2-8 USING COMPRESSED AIR SAFELY• Always wear goggles, face shield, or other eye protection when usingcompressed air to clean equipment.• Do not allow compressed air to contact your skin. If compressed air enters yourskin, obtain medical help immediately.• Do not use compressed air to clean dust and dirt from clothing.• Ensure that the nozzle is equipped with a chip guard.• Never use compressed air that exceeds 30 psi.• Hoses should not be strung across floors or aisles where they are liable tocause a trip hazard. When possible, air supply hoses should be suspendedoverhead.• Hose ends must be secured to prevent whipping if an accidental cut or breakoccurs.• Never point pneumatic tools at a person.• Do not use compressed air to dry roller bearings. The air can cause the bearingto rotate at an extremely high speed and disintegrate.• Turn off the air supply before disconnecting a pneumatic tool (unless equippedwith a quick-disconnect coupling).2-9 BATTERY HANDLING AND MAINTENANCE• If contact with battery acid occurs, administer the following first aid treatment toself or others:– External contact – Flush with water.Service Manual Rev 01 – 05/10 2-8P/N 24933-000