Download complete manual - pdf - Xtreme Manufacturing

Transmission, Axles & DriveshaftsXR620/621/842/1045/1245/1254/1267/1534/2050/30346-4 LUBRICATE DRIVE SHAFTSAFTER FIRST 50 HOURSOF OPERATION ANDEVERY 250 HOURS OFOPERATIONPerform the following procedure to lubricate the front and rear driveshafts:PersonnelSpecial tools and equipment– TASK REQUIREMENTS –One mechanicSafety glassesWheel chocks (4)CreeperGrease gunParts and consumable materials Danger tags (2)Grease, extreme pressure, NLGI #2INITIAL SET-UP1. Park forklift on level surface.2. Set Travel Select lever to NEUTRAL (N).3. Set Parking Brake switch to ON.4. Retract boom and lower carriage. Allow sufficient space to open forklift covers.5. Set Ignition switch to OFF.6. Attach danger tags to steering wheel and ignition key. Refer to para. 2-5, for lockout-tagoutprocedure.7. Place wheel chocks in front of front tires and behind rear tires.LUBRICATE DRIVE SHAFTS1. See Figure 6-1 for location of driveshaft grease fittings. Each driveshaft has three grease fittings.2. Gain access to underside of forklift chassis.3. Lubricate front and rear drive shaft grease fittings in accordance with para. 6-4.Service Manual Rev 01 – 05/10 6-4P/N 24933-000