Download complete manual - pdf - Xtreme Manufacturing

Checkout ProceduresXR620/621/842/1045/1245/1254/1267/1534/2050/30342. Set Parking Brake switch to OFF.3. Set Travel Select lever to REVERSE (R).4. Select 4 th gear.5. Release Service Brake pedal slowly to deactivate RAS system.RESULTS1. The Rear Axle Locked light should go OFF.2. The left front tire must return to the ground.3. The forklift may travel in reverse during this test. Allow the forklift to equalize weight on all four tireswithout depressing service brake.NOTE: The operator can toggle the RAS between Locked Mode and Restricted FloatMode simply by depressing or releasing the Service Brake pedal. The Rear Axle Lockedlight must come on and go out consistent with the mode change.TEST NO. 6This test verifies frame sway and RAS operation in Restricted Float Mode (Travel Mode).TEST SETUP1. Position forklift on level surface.2. Use the Frame Sway control to level the frame.3. Depress Service Brake pedal.4. Raise boom above 45 degrees.5. The Rear Axle Locked indicator light comes ON.6. Move range selector to 4 th and Travel Select lever to FORWARD (F) or REVERSE (R).7. Release Service Brake pedal to deactivate Rear Axle Locked Mode. The Rear Axle Locked light mustcome on and go out consistent with mode change.8. Press Frame Sway override button and sway frame no more than 7 degrees left while holding SwayControl lever full stroke. (Operator controls frame sway travel and is responsible for maintainingcorresponding forklift stability.).9. Repeat frame sway towards right under same conditions and verify comparable performance.RESULTSThe frame should sway in the Fast Mode and the front wheel may rise slightly but should return to theground when frame swaying is stopped.Service Manual Rev 01 – 05/10 11-5P/N 24933-000