Download complete manual - pdf - Xtreme Manufacturing

EngineXR620/621/842/1045/1245/1254/1267/1534/2050/3034DRAIN OIL FROM CRANKCASE1. Open engine cover (Figure 1-2).2. Position suitable container below engine oil pan.3. See Figure 5-6. Remove oil pan drain plug (1) and O-ring.4. Drain engine oil into container.REPLACE ELEMENT-TYPE OIL FILTER1. See Figure 5-8. Put suitable container below oil filter (A4).2. Remove plug (A2) and drain oil from filter.3. Install ½” square drive ratchet into recess (A1) and remove casing (A3).4. Discard old filter element.5. Clean filter casing and replace seal (B2).6. Install new filter element (B1) into casing and rotate element to locate it into position.7. Install new seal on drain plug (A2).8. Torque plug to 9 ft-lbs.9. Lubricate seal (B2) with clean engine oil.10. Fill casing with clean engine oil.11. Install filter (B1) into casing.12. Torque casing (A3) to 18 ft-lbs.13. Remove container and properly dispose of engine oil.Figure 5-8. Element-Type Oil FilterService Manual Rev 01 – 05/10 5-14P/N 24933-000