Download complete manual - pdf - Xtreme Manufacturing

Checkout ProceduresXR620/621/842/1045/1245/1254/1267/1534/2050/3034RESULTSThe rear axle must remain locked with no oscillation and the left front tire must remain airborne.TEST NO. 3This test verifies that the parking brake activates RAS (Locked Mode).TEST SETUP1. Keep Travel Select lever set to NEUTRAL (N).2. Set Parking Brake switch to ON.3. Move Travel Select lever to F and select 4 th gear.4. Fully release Service Brake pedal.RESULTSThe rear axle remains locked with no oscillation and the left front tire remains airborne.TEST NO. 4This test verifies frame sway maintains a four-point stance while operating in Slaved Mode.TEST SETUP1. Move Travel Select lever to NEUTRAL (N).2. Set Parking Brake switch to ON.3. Verify frame sway will not function unless Interlock button is depressed, then activate button andframe sway left about 5 degrees pause then right about 5 degrees beyond the start point.4. During test verify, frame must sway in Reduced Speed Mode both directions, the Rear Axle Lockedlight remains ON and the front tire remains off the ground.RESULTSAlthough the tire's height off the ground may change slightly due to the changes in lateral weightdistribution, the front to rear axle oscillation relationship is retained.TEST NO. 5This test verifies that release of the service brake deactivates the RAS system.SETUP1. Depress Service Brake pedal until Rear Axle Locked light comes ON.Service Manual Rev 01 – 05/10 11-4P/N 24933-000