Download complete manual - pdf - Xtreme Manufacturing

Checkout ProceduresXR620/621/842/1045/1245/1254/1267/1534/2050/3034Section 11Check-Out Procedures11-1 CHECK OPERATION OF REAR AXLE STABILIZATION SYSTEMPerform the following procedure to check the operation of the Rear Axle Stabilization System (RAS):– TASK REQUIREMENTS –PersonnelSpecial tools and equipmentParts and consumable materialsOne operator and one observer8" X 8" wood blockHead protectionNoneThe test area must be cleared of personnel and objects which may pose a hazardin case the forklift rolls over during the test.If the forklift starts to roll over, DO NOT attempt to get out of the cab. Stay in theseat. The cab is designed to provide protection to the operator in the event that theforklift rolls over. Leaving the cab may result in serious injury or death.PRELIMINARY SET-UP1. Post an observer to observe procedure and to render immediate aid if necessary.2. Remove any attachments from carriage adapter.3. Verify Boom Angle indicator (Figure 11-1) swings freely without drag.4. Place 8" X 8" wood block in front of left front wheel.5. Enter cab and adjust seat.6. Fasten and adjust seat belt.7. Start engine. Note that all tests are conducted at idle speed (approximately 1,000 rpm).Service Manual Rev 01 – 05/10 11-1P/N 24933-000