DELOREAN WORKSHOP MANUAL - Free

Ht^l
p^*fe
T^l
•v?^H
r^r
N:08:14 Heating and Air Conditioning
INSTALLING VACUUM
RESERVOIR - Fig. 51
VACUUM
RESERVOIR
TO A/C
SELECTOR
SWITCH
GROMMET
NON-RETURN VALVE
(NOTE ARROWS POINT
TO ENGINE
Fig. 51
Reverse the removal procedure ensuring that the
vacuum pipe connections are as shown.
REMOVING AIR CONDITIONING
COMPRESSOR HOSES
1. De-pressurize air conditioning system (see
refrigerant handling precautions — Section
N:07:01).
2. In order to release the hoses the body must be
raised from the frame slightly to provide
clearance. Raise car on lift.
3. Remove all screws securing the radiator air
duct to the body, spoiler and intake grille, and
withdraw the duct.
4. Remove both air deflector plates from
underside, between frame and body, on each
side of engine bay by releasing their screws
and clips.
5. From inside the luggage compartment, remove
the brake master cylinder access cover and fuel
filler neck cover.
6. Remove the steering column upper universal
joint pinch bolt. Slacken lower universal joint
to column pinch bolt, and slide lower column
into lower universal joint, and off upper steering
column (refer to Steering Section).
7. Remove two nuts securing brake master
cylinder to servo and separate. Support the
master cylinder clear of the servo but do not
strain Brake Pipes. Seal open ends of both
components to prevent dirt ingress.
8. Remove body mounting bolt each side of
engine bay above rear spring abutment.
9. Remove four screws securing charcoal canister
panel to LH rear pontoon. Withdraw panel and
canister, and lay aside.
10. Release cold air intake trunking from air
temperature flap unit and push trunking into
RH rear pontoon.
11. Through the aperture thus exposed, release
the rear body mounting bolt insidgeach rear
pontoon. "?^i
•;^
12. From the car interior, remove the,.jwb body
mounting bolts and one seat >eT| i^buriting
bolt on each side of the centr0@tfi$(\
— ~*3£ =?«-- '
>*•
f&