DELOREAN WORKSHOP MANUAL - Free

2. Remove the windshield and lay on soft surface
with inside facing up.
3. Apply a bead 12.7 mm (Vz") wide of Betaseal
around the perimeter on the interior side of the
glass.
4. Prepare and install windshield on vehicle.
5. Water test windshield for leaks, allowing at
least six hours after installation. Fill leaks with
Betaseal if necessary.
6. Let Betaseal dry approximately six hours at a
constant room temperature then clean and trim
excess with a razor blade knife.
7. Position and secure windshield rear view
mirror.
8. Position and secure cowl screen.
9. Position and secure windshield header panel
and retainer.
10. Position and secure left and right "A" post
finisher panels.
11. Position and secure inner and outer door seals.
|SRJ-
05J-
!'»?